Yes, you can use the selected line output of the Source to feed the DAC output to another device for mixing, mastering, etc. HOWEVER, you cannot feed the final result out of your DAW and back into the speaker section of the Source, or you… READ MORE Can I record the output of the Source’s DAC?
Dangerous gear does not get extremely hot. However, we always recommend leaving blank spaces anyway. More ventilation always equals longer gear life, no matter how hot or cool your gear runs. Do not rack your Dangerous gear next to very hot gear such as power… READ MORE Do I need to leave blank rack spaces above/below my gear?
Please view the Aggregate document on the Source product page, which details the steps needed to add it as an aggregate device.
The Source was designed to have an easily replaceable power adapter. You can order one from an authorized Dangerous Music dealer (part# DMPSU-SRC) or pick up an equivalent at your closest electronic store. The specs are: 12 volt DC output, 1.5 A minimum, and center-positive… READ MORE My power adapter has died, been lost, or is beginning to fail.
12 3/4″ Wide x 1 5/8″ High x 8″ Deep
Burr Brown PCM1789PW
The Source D/A’s are 8x upsampling when playing at a 44.1kHz rate, 4x at 88.2 and 2x at 192. They run at either 352.8kHz (44.1, 88.2, 176.4) or 384kHz (48, 96, 192). The decoder detects the frequency and selects the upsampling mode automatically.
Yes! The Source headphone amp is quite powerful, and can drive even 600ohm headphones. Just remember that you will not get the same amount of volume that you would with low impedance headphones.