“The switching of inserts is managed by beefy relays that are as transparent as any I’ve ever heard.”
“One of the best features of the LIAISON is the monitor outs…you can monitor the signal at four points in the chain: before and after Bus A and B. The usefulness of this feature is huge, and Dangerous deserves major props for including it!”
“The LIAISON as a whole imparts no noise or distortion to your signal.”
“The Dangerous LIAISON fels like engaging light-speed for my workflow..and make no mistake: workflow IS sound. The sheer speed at which you can do critical comparisons of entire signal chains does have a direct and positive impact how your music will sound.”
“LIAISON has the potential of turning you into an audio ninja”
“…using the LIAISON is dead simple”
“I think of LIAISON not as an insert switcher, but as a creativity enabler.”
“LIAISON gives you the impetus to rethink how you record, mix, and master your music”
“The LIAISON is really important – I can do a lot of combinations of chaining gear and I am able to work a lot faster. Before the LIAISON [I had to] switch the patchbay and compare the sounds. Now I am 20-times faster than before,… READ MORE Antoine “Chab” Chabert
“I believe the main hang-up for most people is that they just don۪t want to deal with cables and patching. They want it to be fast, and the LIAISON is very fast.”
Dangerous gear does not get extremely hot. However, we always recommend leaving blank spaces anyway. More ventilation always equals longer gear life, no matter how hot or cool your gear runs. Do not rack your Dangerous gear next to very hot gear such as power… READ MORE Do I need to leave blank rack spaces above/below my gear?
The resistors are only needed on the outputs of your gear, and they will be 100k resistors wired from pin 2 to ground and pin 3 to ground. The idea is to have a resistor to ground in order to discharge any voltage caused by… READ MORE I want to connect gear with floating outputs, how do I wire bleeder resistors? Do I need them if my transformer is center-tapped? Do I need them on inputs and outputs?
“Being able to switch devices from one bus to the other is extremely useful. The fast switching is amazing!”
“The Dangerous LIAISON is incredibly exciting. To have a device that lets you so easily switch between processors, swap the order of processors, do quick A-B comparisons of signal chains. It makes my work better!”
There is no excerpt because this is a protected post.
“The LIAISON is such a hip device. To be able to choose between different outboard gear immediately, and change the order of it in the signal path immediately is so useful!”
“Integrates with the MASTER seamlessly, and they work as one well-designed mastering console with lots of flexibility in routing. The cleanest and most transparent insert switching I’ve ever used.”
“Ultra fast switching, and the four memory locations makes comparing different inserts easy.”